FOCUS 200 PLUS Installation and Setup Guide
18-6
Testing
•
Test the operating panel display and sounder and local bell.
•
Walk-test the areas protected by motion detectors, and test door and window contacts.
•
Test security groups before closing, and see any points that may be abnormal.
•
View points that have been bypassed for test purposes.
•
Test holdup alarm, fire alarm, supervisory (CCM), and burglar alarm devices (and bell) without
initiating an alarm signal to the central station.
Printout
•
Printout can be commanded for up to 60 of the most recent alarm messages that have been stored,
or up to 500 of the most recent messages.
Naming
•
Establish or change a name assigned to each BA group.
•
Establish or change a name to each point.
•
Establish or change a person’s name to each user code number.
Viewing
•
Point status.
•
User name and privilege level.
•
Time of day.
•
Open and close schedules, both permanent and temporary.
•
Contents of alarm memory.
•
Contents of history log.
Downline Loading
•
Reset Memory (SRAM).
•
Start downline load.
•
Enter, via operating panel, all basic data to get system installed and tested.
Note:
All remaining data can be downline loaded or entered in hex via an operating panel.
To Next Page
Loading...
Need help?
General
