5-6 Installation 5702269-C
Advanced Energy
®
Connecting a Remote Passive Panel
Connections for a remote passive front panel are made through the female, 15-pin,
subminiature-D connector labeled MONITOR on the rear panel. The rear of the
remote passive panel features a male, 15-pin, subminiature-D connector. Use the cable
provided with the remote passive panel to connect the panel to your Pinnacle Plus+
unit.
Connection for User Port Control
Please reference the “I/O Communication and Control” chapter for instructions on
connecting your analog/digital interface.
Note: To reduce EMI interference, we recommend using shielded cable to connect to
the User port.
Note: Grounding the User port at the power supply reduces noise interference. To
avoid ground loop problems, you should typically ground only one end.
Connecting to the Standard Serial Port
This interface lets you use most parameters of the AE Bus communications protocol
during serial communications with a host computer. Please reference the “I/O
Communication and Control” chapter for details on making this connection.
Note: To reduce EMI interference, we recommend using shielded cable to connect to
the serial port.
Connection for Serial (Host) Port Control
Please reference the “I/O Communication and Control” chapter for instructions on
connecting your serial communications (Host) port.
Note: Any time you remove one Host card and replace it with another, you must
restore all system defaults. Restoring defaults will reset User limits and ensure
the Pinnacle Plus+ unit recognizes the new Host card.
Note: To reduce EMI interference, we recommend using shielded cable to connect to
the Host port.
To Next Page
Loading...