4-42 I/O Communication and Control 5702269-C
Advanced Energy
®
5. Rotate the MODIFY knob to select a value between 0.00 s to 600 s (in 0.01 s
increments).
Note: If you turn the MODIFY knob quickly, the counts per click setting takes
effect.
6. Press ENTER; if you have indicated that your recipe contains more than one step,
the display returns to the RAMP TIMER screen so that you can enter recipe values
for the next step.
7. Repeat Steps 2 through 7 as needed.
Note: If you assign 0 run time for the final recipe step, the unit will switch to
continuous output when it reaches set point for this step. In this situation,
to turn off output, you must send an off command (using the OFF button or
the appropriate User port signal or serial port command) or you must have
already programmed a joules set point.
To set the recipe type:
1. From the RECIPE menu options, press TYPE.
2. A screen displays that allows you to set the type as: TIMED, JOULE
CONTINOUS, or JOULE DISCRETE.
Use the Modify knob to make your selection. Press ENTER to save your
selection.
3. If you set the recipe type to be JOULE CONTINOUS, a REPEAT menu option
displays. Select REPEAT to enter the number of recipe repetitions. Use the
Modify knob to enter an amount between 1 and 65535.
Note: The recipe repetitions feature is only available with the JOULE
CONTINUOUS option.
4. Press ENTER to save your selection.
Setting Joule Mode
PROCESS → CONTROL → JOULES
This option lets you use joule mode, a method of automatically delivering a specified
number of joules to the target. Choose THRESHOLD to specify an output level to
begin calculation and thereby enhance the accuracy of the calculation by disabling the
calculation during ignition. Choose ENABLE to enable or disable joule mode. Choose
SETPT to program the number of joules you want to be delivered.
Note: If a timed recipe is active, the timed recipe overrides the joule feature.
To enable joule mode:
1. Press PROCESS → CONTROL → JOULES → ENABLE.
To Next Page
Loading...