MAINTENANCE
2-14
2. Remove spark plug and rotate engine to TDC on the
compression stroke. There are 2 places align TDC, One locates
in engine oil filling cap of upper right crankcase, another locate
at in inspection cover of right cylinder dead.
3. Insert a 0.1 mm feeler gauge between end of intake
and adjuster screw.
4. If adjustment is required, loosen the locknut and turn
until the proper clearance is obtained.
5. When clearance is correct, hold adjuster screw and tighten
locknut securely.
6. Re-check the valve clearance.
7. Repeat steps 3-5 to adjust the exhaust valve clearance.
Valve Clearance
In: 0.1 mm
Ex: 0.12 mm
ENGINE MOUNTS LOCATION
Inspect engine mounts for cracks or damage.
Front-
Engine Fastener Torque
Check engine fasteners and ensure they are tight.
Engine Mount Torque Value: 40 Nm (30 ft. lbs.)
To Next Page
Loading...
Need help?
General
