Aeon COBRA 400 2012 User Manual

BRAKES
8-8
9. Remove the disc blots then disc.
10. Remove the speedometer sensor.
11. The front left hand brake use same procedure.
SHUNT REMOVAL
4. The shunt system is hydraulically actuated.
◎ When the right foot brake lever (master cylinder) is applied, the
two front brake calipers and a rear caliper are active and under
pressure.
◎ When the right front brake lever (master cylinder) is applied, the
two front brake calipers are active and under pressure.
◎ When the right front brake lever (master cylinder) is applied, the
rear brake caliper is active and under pressure.
1. Remove two mounting bolts under frame.
2. Remove all banjo bolts then shunt.
3. Inspect two piston’s o-ring and rubber cups surface for wear
or other damage. Replace an assembly if necessary.
FRONT BRAKE – BLEEDING/ FLUID
CHANGE
NOTE: This procedure should be used to change
fluid or bleed brakes during regular maintenance.

Aeon COBRA 400 2012 Specifications

General

Brand	Aeon
Model	COBRA 400 2012
Category	Offroad Vehicle
Language	English