ENGINE
4-36
ENGINE REASSEMBLY
CRANKSHAFT AND CAM/ OIL CHAIN
INSTALLATION
Lubricate all bearings with clean engine oil before assembly.
1. Support the crankcase on blocks.
2. Install shift sensor onto crankcase.
3. Install the balance shaft. Turn the flat up.
4. Install the PTO end of the crankshaft.
NOTE: Use care not to damage the crankshaft end.
The balance shaft flat must square with crankshaft
PTO end.
3. Install 2 Pins onto crankcase.
Install a new gasket onto the right hand crankcase half.
Applying a thin amount of crankcase sealer to the gasket will
help hold it in place.
4. Place right of crankcase on crankshaft and crankcase.
To Next Page
Loading...
Need help?
General
