Software 101
4510001 REV B - 220620
soon, or is too far downstream, causing labels to be applied too late (see “Work
Detective Sensor” on page 37).
o Incorrect Film Drive Wheel Position:
The Film Drive Wheels are too tight against the Film Drive Bearings, so the film
cannot move through, or the Film Drive Wheels are too far from the Applicator
Bearings, so they not advancing the film with precision (see “Film Drive Wheels:
Unlocking/Adjusting/Locking” on page 112).
o Incorrect Applicator Wheel Position:
The Applicator Wheels are too far from the Applicator Bearings, so they are
occasionally slipping against the label film rather than pushing it (see “Applicator
Wheels: Unlocking/Adjusting/Locking” on page 115).
To Next Page