Agilent Technologies 35670A - Page 699

Front Panel Key GPIB Command
[ SERIAL SETUP ]
[ BAUD RATE ] SYSTem:COMMunicate:SERial[:RECeive]:BAUD 300~9600
[ BITS/CHAR ] SYSTem:COMMunicate:SERial[:RECeive]:BITS 5~8
[ STOP BITS ] SYSTem:COMMunicate:SERial[:RECeive]:SBITs 1~2
[ PARITY ] SYSTem:COMMunicate:SERial[:RECeive]:PARITY[:TYPE] NONE|EVEN|ODD
[ PRTY CHK ] SYSTem:COMMunicate:SERial[:RECeive]:PARITY:CHECk OFF|0|ON|1
[ RCVR PACE ] SYSTem:COMMunicate:SERial[:RECeive]:PACE NONE|XON
[ XMIT PACE ] SYSTem:COMMunicate:SERial:TRANsmit:PACE NONE|XON|DSR
System
Utility
[ SHOW LAST MESSAGES ] DISPlay:VIEW MESS
[ CALIBRATN ]
[AUTO CAL ON OFF ] CALibration:AUTO OFF|0|ON|1|ONCE
[SINGLE CAL ] CALibration:AUTO ONCE
[SAVE CH1 CAL TRACE ]
[ INTO D1 ] TRACe:DATA D1,CAL1
[ INTO D2 ] TRACe:DATA D2,CAL1
[ INTO D3 ] TRACe:DATA D3,CAL1
[ INTO D4 ] TRACe:DATA D4,CAL1
[ INTO D5 ] TRACe:DATA D5,CAL1
[ INTO D6 ] TRACe:DATA D6,CAL1
[ INTO D7 ] TRACe:DATA D7,CAL1
[ INTO D8 ] TRACe:DATA D8,CAL1
[SAVE CH2 CAL TRACE ]
[ INTO D1 ] TRACe:DATA D1,CAL2
[ INTO D2 ] TRACe:DATA D2,CAL2
[ INTO D3 ] TRACe:DATA D3,CAL2
[ INTO D4 ] TRACe:DATA D4,CAL2
[ INTO D5 ] TRACe:DATA D5,CAL2
[ INTO D6 ] TRACe:DATA D6,CAL2
[ INTO D7 ] TRACe:DATA D7,CAL2
[ INTO D8 ] TRACe:DATA D8,CAL2
[SAVE CH3 CAL TRACE ]
[ INTO D1 ] TRACe:DATA D1,CAL3
[ INTO D2 ] TRACe:DATA D2,CAL3
[ INTO D3 ] TRACe:DATA D3,CAL3
[ INTO D4 ] TRACe:DATA D4,CAL3
[ INTO D5 ] TRACe:DATA D5,CAL3
[ INTO D6 ] TRACe:DATA D6,CAL3
[ INTO D7 ] TRACe:DATA D7,CAL3
[ INTO D8 ] TRACe:DATA D8,CAL3
Cross-Reference from Front-Panel Keys
to GPIB Commands
B-27