Agilent Technologies 35670A Manual&Nbsp;

-212: Arm ignored.
Arm ignored when arm type is not MANUAL ARM.
Arm received when not waiting for arm.
-220: Parameter error.
Invalid Instrument State Parameter.
-221: Settings conflict.
Capture does not contain tach data.
Capture frequency is not compatible with this measurement.
Data edit invalid for Display Format WATERFALL.
Invalid program state change requested.
LogX not valid for negative X axis.
Marker function result not available.
Meas Data selection invalid for Display Format WATERFALL.
Measurement mode incompatible with command.
No TRIGGER With SWEPT SINE Instrument Mode.
No WATERFALL display with DATA REGISTER, ORBIT, or CAPTURE data.
No WATERFALL display with ORBIT Meas Data or NYQUIST or POLAR Trace Coord .
No WATERFALL display with ORDER ANALYSIS Instrument Mode and TRACK ON.
No WATERFALL display with ORDER TRACK data.
No WATERFALL display with SWEPT SINE Instrument Mode.
No WINDOW With HISTOGRAM Instrument Mode.
No WINDOW With OCTAVE Instrument Mode.
No WINDOW With SWEPT SINE Instrument Mode.
SOURCE LEVEL is 0 Volts, measurement paused.
Synthesis table must be pole-zero.
Zoom capture data cannot be used with this measurement.
-222: Data out of range.
Data out of range.
Out of range: value not changed.
-224: Illegal parameter value.
REAL format length is only 32 and 64.
-230: Data corrupt or stale.
Data does not contain SDF header information.
-240: Hardware error
Hardware error (see Fault Log).
-241: Configuration error
OPTION AY6 Add 2 Input Channels not installed.
-250: Mass storage error.
Bad mass storage parameter.
Bad or unformatted disk.
Error Messages
Execution Errors
C-7

Agilent Technologies 35670A Specifications

General

Brand	Agilent Technologies
Model	35670A
Category	Measuring Instruments
Language	English