Agilent Technologies 35670A - Page 733

Measurement Data Specified Trace Coordinates
Type of Measurement
CALC:FEED?
Linear or
Logarithmic
Magnitude
CALC:FORM MLIN
dB Magnitude
CALC:FORM MLOG
Phase/Unwrapped
Phase
CALC:FORM
[PHAS|UPH]
*
Real/Imaginary
CALC:FORM
[REAL|IMAG]
windowed time
CALC:FEED ‘XTIM:VOLT:WIND’
VPK DBV DEG VPK
*
This is the default unit. You can select radians (RAD).
**
This is the default unit. You can specify VPK using the CALC:UNIT AMPL command.
*** This is the default unit. The unit is S (seconds) if order track is on (SENSe:ORDer:TRACk:STATe ON).
Determining Units
E-3