Chapter 5 243
Post-Repair Procedures
Configuring a Replacement CPU Assembly
Entering the Serial Number
1. Press
System, More until (2 of 3) is displayed, Show System,
Service Password, 7378423, and Enter. The Serial Number softkey
that was previously shown as inactive (grayed out) should now be
shown as active (black).
CAUTION You have only one chance to enter the serial number into the
replacement processor memory. Ensure that the number you enter
matches the number on the serial number tag on the rear panel. Use
extreme care when entering the number from the front panel.
2. Press
Serial Number—alpha editor will be activated—and carefully
enter the serial number. If you make an error, press
Backspace.
For an explanation of the use of the alpha editor, refer to “Using the
Alpha Editor Menu” on page 258.
3. Then press
Done to write the serial number to the instrument
memory.
Entering the Time and Date
1. Press
System, Time/Date, Set Time, and enter the time in the format
hh.mm.ss. For example, 15.25.30 for 15 hours 25 minutes and 30
seconds. Press
Enter.
2. Press
Set Date and enter the date in the format mm.dd.yyyy. For
example 05.11.1999 for May 11, 1999. Press
Enter.
Entering the IP Address and Host Name
To enter the IP Address and Host Name, refer to “Entering IP Address
and Host Name” on page 247.
To Next Page
Loading...
Need help?
General
