SCPI Programming Reference
This section contains information to help you program the Agilent Truevolt Series digital multimeters over a remote
interface using the SCPI programming language.
Introduction to the SCPI Language
Commands by Subsystem
Command Quick Reference
SCPI Error Messages
Power-On and Reset State
Related Information
IO Libraries and Instrument Drivers
The Agilent IO Libraries Suite software and installation instructions are on the Agilent Automation Ready CD-ROM
provided with your instrument (optional for 34460A).
You can also download the Agilent IO Libraries Suite software, along with IVI-COM and LabVIEW drivers, from the
Agilent Developer Network at www.agilent.com/find/adn.
Agilent Truevolt Series Documentation
This documentation is provided on a CD-ROM that is shipped with your instrument (optional on 34460A). You can also
download these documents at www.agilent.com/find/truevolt.
For information about connecting instruments to USB, LAN and GPIB interfaces and how to configure and troubleshoot
these interfaces, refer to the Agilent USB/LAN/GPIB Interfaces Connectivity Guide. This guide is provided on the Agilent
Automation Ready CD-ROM, and you can download it at www.agilent.com/find/connectivity.
Web Interface
The 34461A and 34460A with option 34460A-LAN or option 3446LANU provides a Web Interface built into the
instrument. You can use this interface over LAN for remote access and control of the instrument via a Web browser.
See Web Interface for details.
100 Agilent Truevolt Series DMM Operating and Service Guide
To Next Page
Loading...
Need help?
General
