CALCulate Subsystem Introduction
The CALCulate subsystem receives real-time data from the measurement hardware and sends them to reading
memory. It also optionally performs the following math operations, as shown in the diagram below:
l Scaling
l Statistics
l Limit checking
l Histogram
Only calculations enabled by CALC:SCAL:STAT, CALC:TRAN:HIST:STAT, CALC:LIM:STAT, and CALC:AVER:STAT are
performed.
Parts of the CALCulate Subsystem
CALCulate:CLEar[:IMMediate]
SCALing Subsystem
AVERage Subsystem
LIMit Subsystem
HISTogram Subsystem
Agilent Truevolt Series DMM Operating and Service Guide 117
To Next Page
Loading...
Need help?
General
