Adjustments
You will need a test input cable and connectors set and a low thermal input short, Agilent 34172B, to adjust the
instrument (see Input Connections). Two input shorts are recommended for the 34461A.
Gain Adjustments
ADC and Zero Adjustments
Gain and Flatness Adjustments
AC Voltage Low Frequency Gain and Flatness Calibration
AC Voltage Gain and Flatness Calibration
AC Current Gain and Flatness Calibration
Frequency Accuracy Calibration
DC Voltage Gain Calibration
Ohms Gain Calibration
DC Current Gain Calibration
AC Current 10 A Full Scale Calibration (34461A only)
DC Current 10 A Full Scale Calibration (34461A only)
Finishing Adjustments
332 Agilent Truevolt Series DMM Operating and Service Guide
To Next Page
Loading...
Need help?
General
