Agilent Technologies Truevolt Series User Manual

Execution Errors (-200…)
-200,"Execution error"
-203,"Command protected"
-203,"Command protected; external trigger requires license LAN"
-203,"Command protected; License required"
-203,"Command protected; requires license LAN"
-203,"Command protected; requires license SEC"
-210,"Trigger error"
-211,"Trigger ignored"
-213,"Init ignored"
-214,"Trigger deadlock"
-220,"Parameter error"
-221,"Settings conflict"
-221,"Settings conflict; *TRG when TRIG:SOUR BUS not selected; trigger ignored"
-221,"Settings conflict; 10A current terminals not available with rear terminals; terminals set to 3A"
-221,"Settings conflict; CALC function not allowed in current measurement function; CALC:STAT OFF set"
-221,"Settings conflict; CALC not allowed in current measurement function"
-221,"Settings conflict; CALC not allowed in current measurement function; CALC:STAT OFF set"
-221,"Settings conflict; CALC:AVER:STATe OFF set"
-221,"Settings conflict; CALC:TRAN:HIST:STATe OFF set"
-221,"Settings conflict; CALCulate not allowed in current function"
-221,"Settings conflict; cannot delete state selected and enabled for automatic power-on recall"
-221,"Settings conflict; histogram lower range > upper range; CALC:TRAN:HIST:RANG:AUTO ON set"
-221,"Settings conflict; lower limit > upper limit; CALC:LIM:UPP set to CALC:LIM:LOW value"
-221,"Settings conflict; trigger source is BUS"
-222,"Data out of range"
-222,"Data out of range; value clipped to lower limit"
-222,"Data out of range; value clipped to upper limit"
-223,"Too much data"
-224,"Illegal parameter value"
-225,"Out of memory; measurement data overrun"
-230,"Data corrupt or stale"
-231,"Data questionable"
-240,"Hardware error"
-240,"Hardware error; cannot communicate with measurement hardware"
278 Agilent Truevolt Series DMM Operating and Service Guide

Agilent Technologies Truevolt Series Specifications

General

Brand	Agilent Technologies
Model	Truevolt Series
Category	Laboratory Equipment
Language	English