Parameters for Port Provisioning
...................................................................................................................................................................................................................................
Introduction
For each port type there is a special window to provision the ports. The 1643 AM or
1643 AMS always has two STM-1 or STM-4 line ports and sixteen 2 Mbit/s ports. If
an additional tributary unit is installed, SDSL, 34 Mbit/s, 45 Mbit/s, X.21, or LAN
(Ethernet) ports can also be available.
Port types
The following table shows the port types and which parameters are valid for each port.
Para-
meters
1.5
Mbit/s
2
Mbit/s
SDSL ISDN 34
Mbit/s
45
Mbit/s
X.21 LAN STM-1
optical
or
electrical
STM-1
or 4
line
port mode x xxxxxxxx x
port mode
time
xxxxxxxxx x
2 Mbit/s
signal
mapping
-xxx--- - - -
loopback
state
xxxxxxx-x -
TS0
termination
---x----- -
cable
length
x----x--- -
degraded
signal
threshold
-- - x - - - - x x
optical
wavelength
--------xx
laser
status
--------xx
auto
negotiation
-------x- -
Ethernet - ------x- -
Port
The name of the physical ports consists of two parts separated by a dot. The first part
is related to the slot name, the second part is the port number within that slot.
Example: LP2.1, TP1.3, LAN2.1
Equipment provisioning
...................................................................................................................................................................................................................................
5-62
Alcatel-Lucent - Proprietary
See notice on first page
365-312-807R7.2
Issue 4, May 2007
To Next Page
Loading...
