Result: Depending on the Type of the selected port, a Port Information window
appears. There is a separate
Port Information window for each port type.
...................................................................................................................................................................................................
4
Click Edit and the Edit Port Information window appears.
Result: There is also a separate Edit Port Information window for each port type.
Refer to “Parameters for Port Provisioning” (p. 5-62).
Note: The Loopback State can be changed in the Edit Port Information window.
...................................................................................................................................................................................................
5
Change the Port mode, Auto-Negotiation modeand LPT mode to Enabled and click OK.
Result: The edit window closes and the information window appears with the
Auto-Negotiation mode enabled and also the LPT Mode enabled.
E ND OF STEPS
...................................................................................................................................................................................................
Equipment provisioning
Provisioning ports
....................................................................................................................................................................................................................................
365-312-807R7.2
Issue 4, May 2007
Alcatel-Lucent - Proprietary
See notice on first page
5-61
To Next Page
Loading...
