Alcatel-Lucent 1643 AMS - Page 322

Result: A list of all possible ports (or a ″-″ ) appears for the selected slot.
...................................................................................................................................................................................................
4
Select a port (or a ″-″) from the list for the Reference.
Result: The Working Reference for the timing source is selected (in case a port is
selected) or the Working Reference for the timing source is unassigned (in case ″-″
is selected).
...................................................................................................................................................................................................
5
Click OK to confirm the current settings.
Result: The Assign Timing Reference to Timing Source window is closed and data
is sent to the network element.
...................................................................................................................................................................................................
6
Click Close.
Result: The Provisioned NE Timing Source Information window disappears.
Assign references to timing sources
To assign a working and protection timing reference to a timing source for the 1643
AM or 1643 AMS working in the STM-4 mode with STM-1 tributaries, follow this
procedure:
...................................................................................................................................................................................................
1
Select Provisioning --> Timing --> Timing Sources
Result: The Provisioned NE Timing Source Information window appears.
...................................................................................................................................................................................................
2
Select a source that must be edited from the list and click Assign.
Result: The Assign Timing Reference to Timing Source window appears.
...................................................................................................................................................................................................
3
Select a slot (or a ″-″) from the list under Working Reference.
Result: A list of all possible ports (or a ″-″ ) appears for the selected slot.
...................................................................................................................................................................................................
4
Select a port (or a ″-″) from the list for the Working Reference.
Result: The Working Reference for the timing source is selected (in case a port is
selected) or the Working Reference for the timing source is unassigned (in case ″-″
is selected).
...................................................................................................................................................................................................
5
Select a slot (or a ″-″) from the list under Protection Reference.
Timing provisioning Provisioning timing sources
....................................................................................................................................................................................................................................
7-20
Alcatel-Lucent - Proprietary
See notice on first page
365-312-807R7.2
Issue 4, May 2007
E ND OF STEPS
...................................................................................................................................................................................................