Alcatel-Lucent 1643 AMS - Page 458

• provision the WAN port capacity and the monitoring mode of the SDH channel
• create a VLAN
• provision the Quality of Service (QoS) on the LAN and WAN ports.
Important! TransLAN always advertises to transport untagged traffic in
IEEE802.1D/Q mode, for preservance of e.g. end customer Bridge PDU traffic. For
this purpose, the TransLAN network will assign a default VLAN id (PVID) that is
used only internally to securely transport untagged customer traffic. This PVID is
attached at the ingress port, and removed at egress. Therefore it is not allowed to
send traffic to the TransLAN network that is already tagged with the same VLAN
as the default PVID used in the TransLAN network for this end customer. This
traffic will inevitably be untagged, and might not be useable anymore for the end
customer.
Create a virtual switch
...................................................................................................................................................................................................
1
Select Provisioning → LAN Management → Virtual Switch.
Result: The Virtual Switch List window appears
...................................................................................................................................................................................................
2
Click Add.
Result: The Add Virtual Switch window appears.
...................................................................................................................................................................................................
3
Enter a name of maximum 20 characters in the Virtual Switch Label field (for
example Sales).
...................................................................................................................................................................................................
4
Select Spanning Tree in the Operation Mode area.
...................................................................................................................................................................................................
5
Select TPID value in the Ether Type area.
It is recommended only to provide one of the following two values:
•
0x8100
for IEE802.1Q STP
•
0x9100
for IEEE802.1ad STP (provider bridge mode)
...................................................................................................................................................................................................
6
Select the virtual switch and click Details.
Result: The Virtual Switch List Information window appears.
...................................................................................................................................................................................................
7
Click Edit.
Traffic provisioning Provisioning a virtual switch in spanning tree mode
....................................................................................................................................................................................................................................
8-106
Alcatel-Lucent - Proprietary
See notice on first page
365-312-807R7.2
Issue 4, May 2007