...................................................................................................................................................................................................
8
Select if QoS oversubscription is either Enabled or Disabled if Ether Type is 8100.
...................................................................................................................................................................................................
9
Select if Dynamic VLAN registration is either Enabled or Disabled.
...................................................................................................................................................................................................
10
Attach one or more LAN port(s) to the virtual switch by selecting them in the
Available Port List and shifting them to the group box Selected Port Membership by
clicking on the left arrow button.
...................................................................................................................................................................................................
11
Attach one or more WAN port(s) to the virtual switch by selecting them in the
Available Port List and shifting them to the group box Selected Port Membership by
clicking on the left arrow button.
...................................................................................................................................................................................................
12
Click OK.
Result: The Virtual Switch List window appears
...................................................................................................................................................................................................
13
Select the newly created virtual switch and click Details.
Result: The Virtual Switch List Information window appears.
If tagging mode has been changed from transparent to IEEE, it can take up to 30
seconds until the
Virtual Switch List Information window appears. The reason is
that after a tagging mode switch, the LAN image is restarted. So you should wait
until the LAN image start up has finished, before starting any operation.
...................................................................................................................................................................................................
14
Click Edit.
...................................................................................................................................................................................................
15
Fill in the Virtual Switch Label and the PVID.
Additional info If the LAN port should be configured for untagged traffic, a PVID
must be set. Additionally a VLAN-ID with the same value of the PVID must be
configured otherwise it is not known in the GVRP protocol.
...................................................................................................................................................................................................
16
Click OK.
Result: The Virtual Switch List Information window appears
...................................................................................................................................................................................................
17
Provison LAN port parameters.
Traffic provisioning
Provisioning a virtual switch in spanning tree mode
....................................................................................................................................................................................................................................
365-312-807R7.2
Issue 4, May 2007
Alcatel-Lucent - Proprietary
See notice on first page
8-107
To Next Page
Loading...
