Delete an existing cross-connection
...................................................................................................................................................................................................................................
When to use
When a new traffic plan is implemented or the existing traffic plan is changed.
Related information
This section describes the provisioning of protected transmission paths. The
provisioning of paths with no protection is described in previous section “Provision
Cross Connections without Protection”
The following procedures are used for test and maintenance of the provisioned path.
These procedures are described in Chapter 9, “Traffic maintenance”.
• port provisioning.
• provisioning termination points
• path trace provisioning
• for theoretical information see “Concepts” (p. 9-3).
Before you begin
To delete a cross-connection first determine the following:
• What is the capacity of the cross-connection? VC-12, VC-3, or VC-4?
• Does the cross-connection have SNC protection or is it unprotected (Standard)?
• Between which termination points (TP) is the cross-connection made
• Does the cross-connection to be removed still carry traffic?
Procedure
...................................................................................................................................................................................................
1
Select Provisioning -> Transport -> Cross Connection.
Result: The Cross Connection Filter window appears.
...................................................................................................................................................................................................
2
Select the Cross Connection type, Capacity, Directionality, TP, Slot, Port, and the AU-4
number and select
OK.
Result: The Cross Connection Selection List window appears with all available
cross connections that meet the selected filter criteria. The filter criteria are
displayed in the filter area of the Cross Connection Selection List window.
...................................................................................................................................................................................................
3
Select the cross-connection to be deleted from the list and click Delete in the CC area.
Result: A confirmation window appears.
...................................................................................................................................................................................................
4
Click Yes to confirm the removal of the cross-connection.
Traffic provisioning
...................................................................................................................................................................................................................................
365-312-807R7.2
Issue 4, May 2007
Alcatel-Lucent - Proprietary
See notice on first page
8-157
To Next Page
Loading...
