Parameters for provisioning termination points
...................................................................................................................................................................................................................................
Introduction
The following Termination Points can be provisioned for the 1643 AM or 1643 AMS :
VC-12, VC-3, VC-4, TU-12, TU-3.
The following list shows which parameters can be set for which termination points
• TP mode: VC-12, VC-3, VC-4
• J0/J1/J2 Trail Trace Identifier (path trace): VC-12, VC-3, VC-4, TU-12, TU-3.
• Signal label: VC-12, VC-3, VC-4
• Degraded Signal Threshold: VC-12, VC-3, VC-4, TU-12, TU-3
Selected TP
The name of the selected termination point.
The termination point is selected by the Slot and Port where the termination point
belongs to. The AU4# is 1 when the line ports carry STM-1 signals and 4 when the
line ports carry a STM-4 signal.
The name of the termination points consists of the physical port name (slot name and
port number) followed by the AU-4 number and for low order signals, the VC number
(VC-12 or VC-3). The VC number (also called klm number) consists of:
• k: the number of the TUG-3 inside the VC-4
• l: the number of the TUG-2 inside the TUG-3
• m: the TU-12 number inside the TUG-2.
The following figure shows examples of the TP naming.
TP type
The termination point type indicates where the signal is terminated.
Example: VC-12, TU-3
TP mode
Indicates whether the signal on the termination point will be monitored.
Traffic maintenance
...................................................................................................................................................................................................................................
9-12
Alcatel-Lucent - Proprietary
See notice on first page
365-312-807R7.2
Issue 4, May 2007
To Next Page
Loading...
