When monitored, alarms are generated related to the selected termination point. When
not monitored, no alarms are generated related to the selected termination point.
For TU-12 and TU-3 the TP mode cannot be set by the operator. For TU-12 and TU-3
alarming is ’enabled’ once such TP is in use (i.e. Cross-connect is made to such TU).
J0/J1/J2 trail trace identifier
This area is used to provision a path trace. Provisioning a path trace is described in the
section ″Path Trace Provisioning″.
Signal label
The signal label is part of the path overhead of a VC-n signal and indicates what type
of signal is carried by the container.
Example: Unequipped, asynchronous, TUG structure, ATM
• Signal Label Accepted (HEX., Description) is the signal label of the received signal
• Signal Label Transmit (HEX., Description) is the signal label of the transmitted
signal
Traffic maintenance
Parameters for provisioning termination points
....................................................................................................................................................................................................................................
365-312-807R7.2
Issue 4, May 2007
Alcatel-Lucent - Proprietary
See notice on first page
9-13
To Next Page
Loading...
