Alcatel-Lucent 1643 AMS - Page 644

Result: The Select Port Role window appears.
...................................................................................................................................................................................................
5
In the Select Port Role window select Customer Port and click Next.
Result: The Edit Port Information window appears.
...................................................................................................................................................................................................
6
In the Edit Port Information window set the PVID, select Default Profile for QOS
Mode and click
Ok.
...................................................................................................................................................................................................
7
Click Add Flow Table.
Result: The Add Flow Table window appears.
...................................................................................................................................................................................................
8
Set the Descriptor to none and click Ok.
Result: The Flow Table is added.
...................................................................................................................................................................................................
9
In the Customer Port Information window click Insert Flow Group.
Result: The Insert Flow Group window appears.
...................................................................................................................................................................................................
10
Set the Descriptor to cvid=1&&cup=0 , set the Profile ID and click Ok.
...................................................................................................................................................................................................
11
In the Edit Port Information window select Flow Configuration for QOS Mode, click
Ok and Close.
...................................................................................................................................................................................................
12
Select Performance → PM TP Configuration.
Result: The Select Performance Monitoring Points window appears in the PM
Configuration mode.
...................................................................................................................................................................................................
13
Select Flow TP for PM Point Type, select the Port, select the Flow Table ID and Flow
Group ID from the drop down list and then click
Add and Ok.
Result: The Service Monitor is enabled in the Active Performance Monitoring
Point List
window.
...................................................................................................................................................................................................
14
Click Add.
Performance monitoring Ethernet Service Monitor
....................................................................................................................................................................................................................................
10-62
Alcatel-Lucent - Proprietary
See notice on first page
365-312-807R7.2
Issue 4, May 2007