Ethernet Service Monitor
...................................................................................................................................................................................................................................
When to use
The following procedure is performed when the user wants to enable the Ethernet
Service monitoring counters. The ethernet service flow PM counters are also known as
flow TP PM, provides performance monitoring for an ethernet pack based on traffic
class and color information.
Note: The Ethernet Service Monitor procedure is also applicable to X5IP.
Related information
The items below list other relevant information to this procedure:
• Procedure to set the SDH TP Mode, for the required prior setting of the ports to be
monitored. Refer to “Provision ports” (p. 5-59).
• “Ethernet performance monitoring” (p. 10-12)
• “Concepts” (p. 10-3)
Before you begin
The items below gives information on tasks to perform before beginning the procedure:
• Proper LAN card must be installed in TS2 in order to be able to make performance
LAN measurements.
• A prerequisite for this procedure is to set “Provisioning a virtual switch in spanning
tree mode” (p. 8-105).
• Cross connection should be enabled and VCG should be set to monitored.
Service monitor
Follow this procedure in order to view the Service monitor counters.
...................................................................................................................................................................................................
1
Select Provisioning → LAN Management → Virtual Switch.
Result: The Virtual Switch List window appears
...................................................................................................................................................................................................
2
Select a virtual switch from the list and click Details.
Result: The Virtual Switch Information window appears.
...................................................................................................................................................................................................
3
Select a LAN port and click Port Details.
Result: The Customer Port Information window appears.
...................................................................................................................................................................................................
4
In the Cutomer Port Information window click Edit.
Performance monitoring
...................................................................................................................................................................................................................................
365-312-807R7.2
Issue 4, May 2007
Alcatel-Lucent - Proprietary
See notice on first page
10-61
To Next Page
Loading...
