Ethernet High Priority, Low Priority Traffic Monitor and User
Provisionable LS/SLS Threshold
...................................................................................................................................................................................................................................
When to use
The following procedure is performed when you want to enable the Ethernet High
priority and Low Priority Traffic monitor counters, to set the threshold values for the
Ethernet High Priority Traffic monitor and the granularity of the monitored period. The
high quality and low quality ethernet PM counters provides performance monitoring
for an ethernet pack based on traffic class and color information.
Note: The Ethernet High Priority, Low Priority Traffic Monitor and User Provisionable
LS/SLS Threshold procedure is also applicable to X5IP.
Related information
The items below list other relevant information to this procedure:
• Procedure to set the SDH TP Mode, for the required prior setting of the ports to be
monitored. Refer to “Provision ports” (p. 5-59).
• “Concepts” (p. 10-3)
• “Ethernet performance monitoring” (p. 10-12)
Before you begin
The items below gives information on tasks to perform before beginning the procedure:
• Proper LAN card must be installed in TS2 in order to be able to make performance
LAN measurements.
• A prerequisite for this procedure is to set “Provisioning a virtual switch in spanning
tree mode” (p. 8-105).
• Cross connection should be enabled and VCG should be set to monitored.
• LAN and WAN ports should be changed to Network port role in the Virtual Switch
Information window.
High Priority and Low Priority Traffic Monitor
Follow this procedure in order to view the High and Low priority Traffic monitoring
counters and the User Provisionable LS/SLS Threshold.
...................................................................................................................................................................................................
1
Select Performance → PM TP Configuration.
Result: The Select Performance Monitoring Points window appears in the PM
Configuration mode.
...................................................................................................................................................................................................
2
Select Ethernet HQ Traffic or Ethernet LQ Traffic for PM Point Type and select the
Port and then click
Add and Ok.
Performance monitoring
...................................................................................................................................................................................................................................
10-64
Alcatel-Lucent - Proprietary
See notice on first page
365-312-807R7.2
Issue 4, May 2007
To Next Page
Loading...
