Alcatel-Lucent 1643 AMS - Page 647

Result: The Ethernet High Priority Traffic Monitor or the Ethernet Low Priority
Traffic Monitor
is enabled in the Active Performance Monitoring Point List
window.
...................................................................................................................................................................................................
3
Click Add.
Result: The Performance Monitoring Point Filter window appears.
...................................................................................................................................................................................................
4
Select Ethernet HQ Traffic or Ethernet LQ Traffic for PM Point Type and select the
Port and then click
Ok.
Result: The Edit Performance Monitoring Point window appears.
...................................................................................................................................................................................................
5
Select the measurement period by clicking either Unidir 15 Min or Unidir 24 hr tab
and then enable the counters by marking the Enable Counters check box.
Select the User Provisionable LS/SLS by clicking the PM Attribute tab and then
the Nominal Data Rate and the LS/SLS estimator should be provisioned.
Result: The checkbox Enable Counters is enabled.
The
PM attribute tab is not available for the Ethernet Low Priority Traffic monitor.
...................................................................................................................................................................................................
6
Enable thresholding by marking the Enable Thresholding checkbox.
Result: The threshold crossing functionality is enabled. The systems retrieves the
last saved TR and RTR values from the NE and reports it in each parameter field.
If there is no previously saved TR and RTR values (as for a new termination
point), the system will fill in the default threshold values for those parameters (for
thresholds range, minimum/maximum, and default values, see “Concepts” (p. 10-3).
The Enable Thresholding box is not available for Ethernet Low Priority Traffic
monitor.
...................................................................................................................................................................................................
7
Select OK.
Result: The Edit Performance Monitoring Point Filter window disappears. The
Active Performance Monitoring Points window gets dynamically updated if they
are opened.
...................................................................................................................................................................................................
8
Select Performance -> PM Current Measurements.
Result: The Select Performance Monitoring Points window is displayed. The
ITM-CIT is in measurement mode.
...................................................................................................................................................................................................
9
Click Ok.
Performance monitoring Ethernet High Priority, Low Priority Traffic Monitor and
User Provisionable LS/SLS Threshold
....................................................................................................................................................................................................................................
365-312-807R7.2
Issue 4, May 2007
Alcatel-Lucent - Proprietary
See notice on first page
10-65