Alcatel-Lucent 1643 AMS - Page 674

Result: The Edit NE Software Configuration window appears.
...................................................................................................................................................................................................
3
Click Download.
Result: A window appears allowing for the selection of the appropriate file to be
downloaded.
...................................................................................................................................................................................................
4
Browse to the folder where the new software is stored. The new software can be
downloaded either from floppies or from the hard drive in the PC. Select the file
containing the new software and click
Open.
Result: The Software Download Progress Display window appears and the progress
of the software download is displayed.
To abort the software download click
Abort.
Switch the software stores of the NE
Perform the following steps to switch the software stores of a network element
...................................................................................................................................................................................................
1
Determine whether the MIB (Management Information Base) is compatible with the
new software. If the MIB is not compatible, the MIB cannot be retained and must be
provisioned again with new settings after the software switch or a converted MIB is
provided by ITM-SC.
...................................................................................................................................................................................................
2
Select Provisioning -> Equipment -> NE Software Configuration.
Result: The NE Software Configuration window appears with information about
the software currently stored in the active and backup store of the network element.
...................................................................................................................................................................................................
3
Click Edit.
Result: The Edit NE Software Configuration window appears. Check if the correct
software version is stored in the backup store. After the switch this will be the
active software running the network element.
...................................................................................................................................................................................................
4
Fill in the Retain MIB check box if the information in the MIB should be saved. This
is only possible if the MIB is compatible with the new software. Not retaining the MIB
means that the NE must be provisioned again with the new settings or a converted
MIB must be downloaded from by ITM-SC.
Click
Switch.
Software upgrade Upgrading the software of an NE
....................................................................................................................................................................................................................................
12-12
Alcatel-Lucent - Proprietary
See notice on first page
365-312-807R7.2
Issue 4, May 2007
E ND OF STEPS
...................................................................................................................................................................................................