Alcatel-Lucent 5620 - Page 167

3 — Troubleshooting using network alarms
Alcatel-Lucent 5620 Service Aware Manager, Release 3-125
3HE 05723 TQZZA Edition 01 Troubleshooting Guide
Table 3-74 Domain: tdmequipment
Name: SoftwareUpgradeFailed
Type: configurationAlarm (11)
Probable cause: fileAccessError (90)
Severity: Major
Object Type (class):
SoftwareUpgradeManager
Domain: sw
Implicitly cleared (self-clearing): No
The alarm is raised when an NE
software upgrade using the 5620 SAM
fails.
Name: StatsRetrieveFailed
Type: configurationAlarm (11)
Probable cause: fileTransferFailure (89)
Severity: Major
Object Type (class):
AccountingStatsRetrievalManager
Domain: sw
Implicitly cleared (self-clearing): No
The alarm is raised when the
5620 SAM cannot transfer an
accounting file from an NE.
Name: synchroFailureAlarm
Type: softwareAlarm (19)
Probable cause: synchroFailureAlarm (403)
Severity: Major
Object Type (class):
SoftwareControlModule
Domain: sw
Implicitly cleared (self-clearing): No
The alarm is raised when the flash
card synchronization on an NE fails.
Name: VersionConfigRestoreFailed
Type: configurationAlarm (11)
Probable cause: versionMismatch (405)
Severity: Major
Object Type (class):
BackupRestoreManager
Domain: sw
Implicitly cleared (self-clearing): Yes
The alarm is raised when the restore
procedure on an NE fails because of
a mismatch between the backup file
set version and the NE software
version.
Alarm Attributes Additional information
Name: DS1E1AlarmIndicationSignal
Type: communicationsAlarm (4)
Probable cause: alarmIndicationSignal (96)
Severity: Major
Object Type (class):
DS1E1ChannelSpecifics
Domain: tdmequipment
Implicitly cleared (self-clearing): Yes
The alarm is raised when an NE
reports that a specific DS1 or E1
channel has an AIS alarm condition.
Name: DS1E1Loopback
Type: configurationAlarm (11)
Probable cause: ds1e1Loopback (305)
Severity: Warning
Object Type (class):
DS1E1ChannelSpecifics
Domain: tdmequipment
Implicitly cleared (self-clearing): No
The alarm is raised when an NE
reports that a specific DS1 or E1
channel has a loopback alarm
condition.
Name: DS1E1Looped
Type: communicationsAlarm (4)
Probable cause: farEndLoopback (102)
Severity: Major
Object Type (class):
DS1E1ChannelSpecifics
Domain: tdmequipment
Implicitly cleared (self-clearing): Yes
The alarm is raised when an NE
reports that a specific DS1 or E1
channel has a remote loopback alarm
condition.
Name: DS1E1LossOfSignal
Type: communicationsAlarm (4)
Probable cause: lossOfSignal (99)
Severity: Major
Object Type (class):
DS1E1ChannelSpecifics
Domain: tdmequipment
Implicitly cleared (self-clearing): Yes
The alarm is raised when an NE
reports that a specific DS1 or E1
channel has an LOS alarm condition.
(1 of 3)
Alarm Attributes Additional information
(3 of 3)
Aug 2010
AAAD
8.0 R4