Alcatel-Lucent 5620 - Procedure 6-6 to Configure the Logviewer CLI

6 — 5620 SAM LogViewer
6-20 Alcatel-Lucent 5620 Service Aware Manager, Release
Troubleshooting Guide 3HE 05723 TQZZA Edition 01
LogViewer resets the counters.
iii Enter the following at the prompt to return to display mode:
return ↵
12 Enter the following at the prompt to close LogViewer:
quit ↵
Procedure 6-6 To configure the LogViewer CLI
Perform this procedure to use the LogViewer CLI to configure general CLI application
options.
1 Open the LogViewer CLI.
2 To add a file to the list of files in the open menu, perform the following steps.
i Press ↵ to enter command mode.
ii Enter the following at the root prompt:
include ↵
The following prompt is displayed:
log-include>
iii Enter the following at the prompt:
add ↵
The following prompt is displayed:
File Name (full path)?
Note — The options configured in this procedure apply only to the
current LogViewer CLI session.
Aug 2010
AAAD
8.0 R4