Alcatel-Lucent 5620 - Procedure 6-7 to Specify Plug-Ins Using the CLI

6 — 5620 SAM LogViewer
Alcatel-Lucent 5620 Service Aware Manager, Release 6-21
3HE 05723 TQZZA Edition 01 Troubleshooting Guide
iv Enter the absolute or relative path of the log file that you want to add and
press ↵. LogViewer adds the file to the list in the open menu.
v Enter the following at the prompt to return to the root prompt:
root ↵
3 To configure LogViewer file parsing, perform the following steps.
i Press ↵ to enter command mode.
ii Enter the following at the root prompt:
options ↵
The following prompt is displayed:
log-options>
iii Enter y ↵ at the prompt to confirm the action.
iv To specify whether LogViewer parses the entire log file, enter the following
at the prompt:
parseAll ↵
A confirmation prompt is displayed.
v To force LogViewer to reparse the current log file, enter the following at the
prompt:
reparse ↵
vi If you are prompted to enable parsing of the entire log file, enter y ↵.
vii Enter the following at the prompt to return to the root prompt:
root ↵
Procedure 6-7 To specify plug-ins using the CLI
Perform this procedure to specify a plug-in for the current LogViewer CLI session.
1 Open the LogViewer CLI.
2 Press ↵ to enter command mode.
3 Enter the following at the root prompt:
plugin ↵
Note — The LogViewer CLI supports file drag-and-drop functionality.
Aug 2010
AAAD
8.0 R4