IP Router Configuration
Router Configuration Guide 109
Parameters number — Specifies the maximum number of routes to be held in a VRF context.
Values 1 to 2147483647
log-only — Specifies that if the maximum limit is reached, only log the event. log-only does not
disable the learning of new routes.
threshold threshold — The percentage at which a warning log message and SNMP trap should
be sent.
Values 0 to 100
Default 10
mpls-labels
Syntax mpls-labels
Context config>router
Description This command creates a context for the configuration of global parameters related to MPLS labels.
static-label-range
Syntax static-label-range static-range
no static-label-range
Context config>router>mpls-labels
Description This command configures the range of MPLS static label values shared among static LSP, MPLS-TP
LSP, and static service VC label. Once this range is configured, it is reserved and cannot be used by
other protocols such as RSVP, LDP, BGP, or Segment Routing to assign a label dynamically.
Parameters static-range — Size of the static label range in number of labels. The minimum label value in the
range is 32. The maximum label value is thus computed as {32+ static-range-1}.
Values 0 to 131040 for chassis mode C
Values 0 to 262112 for chassis mode D
Default 18400
bgp-labels-hold-timer
Syntax bgp-labels-hold-timer seconds
[no] bgp-labels-hold-timer
Context config>router>mpls-labels
Description This command configures the BGP labels hold timer on the ingress router.
To Next Page
Loading...
