IP Router Configuration Command Reference
110 Router Configuration Guide
Parameters seconds — Specifies the seconds
Values 0 to 255
sr-labels
Syntax sr-labels start start-value end end-value
no sr-labels
Context config>router>mpls-labels
Description This command configures the range of the Segment Routing Global Block (SRGB). It is a label block
which is used for assigning labels to segment routing prefix SIDs originated by this router. This range
is carved from the system dynamic label range and is not instantiated by default.
This is a reserved label and once configured it cannot be used by other protocols such as RSVP, LDP,
and BGP to assign a label dynamically.
Parameters start start-value — start label value in the SRGB
Values 18432 to 524287
Default none
end end-value — end label value in the SRGB
Values 18432 to 524287
Default None
mss-adj-group
Syntax mss-adjust-group nat-group-id segment-size segment-size
no mss-adjust-group
Context configure>router
config>service>vprn
Description This command associates the MSS adjust group consisting of multiple ISAs with the routing context
in which the application requiring TCP MSS adjust resides.
Default n/a
Parameters nat-group-id — Specifies the NAT group used for TCP MSS adjust.
segment-size — Specifies the value to put into the TCP Maximum Segment Size (MSS) option if
it is not already present, or if the present value is higher.
To Next Page
Loading...
