IP Router Configuration
Router Configuration Guide 117
Values exclusive
When this option is specified, the addresses configured are
exclusively used for services and cannot be assigned to network
ports.
sgt-qos
Syntax sgt-qos
Context config>router
Description This command configures DSCP/Dot1p re-marking for self-generated traffic.
application
Syntax application dscp-app-name dscp {dscp-value |dscp-name}
application dot1p-app-name dot1p dot1p-priority
no application {dscp-app-name | dot1p-app-name}
Context config>router>sgt-qos
Description This command configures DSCP/Dot1p re-marking for applications.
Parameters dscp-app-name — Specifies the DSCP application name.
Values bgp, cflowd, dhcp, dns, ftp, icmp, igmp, igmp-reporter, l2tp, ldp,
mld, msdp, ndis, ntp, ospf, pim, ptp, radius, rip, rsvp, snmp, snmp-
notification, srrp, ssh, syslog, tacplus, telnet, tftp, traceroute, vrrp
dscp-value — Specifies the DSCP value
Values 0 to 63
dscp-name — Specifies the DSCP name.
ipv4-prefix: a.b.c.d (host bits must be 0)
ipv4-prefix-length: 0 to 32
ipv6-prefix: x:x:x:x:x:x:x:x (eight 16-bit
pieces)
x:x:x:x:x:x:d.d.d.d
x: [0 to FFFF]H
d: [0 to 255]D
ipv6-prefix-length: 0 to 128
To Next Page
Loading...
