IP Router Configuration Command Reference
120 Router Configuration Guide
Default no cv-tx
Parameters transmit-interval — Specifies the transmit interval. This parameter is only used if a BFD session
is enabled with CV on an MPLS-TP LSP.
Values 1 sec to 30 sec in 1 second increments
Default 1 second
echo-receive
Syntax echo-receive echo-interval
no echo-receive
Context config>router>bfd>bfd-template
Description This command sets the minimum echo receive interval, in milliseconds, for a session. This is not used
by a BFD session for MPLS-TP.
Default no echo-receive
Parameters echo-interval — Specifies the echo receive interval.
Values 100 ms to 100,000 ms in 1 ms increments
Default 100
multiplier
Syntax multiplier multiplier
no multiplier
Context config>router>bfd>bfd-template
Description This command specifies the detect multiplier used for a BFD session. If a BFD control packet is not
received for a period of multiplier x receive-interval, then the session is declared down.
Default 3
Parameters multiplier — Specifies the multiplier.
Values 3 to 20, integers
Default 3
type
Syntax [no] type cpm-np
Context config>router>bfd>bfd-template
To Next Page
Loading...
