IP Router Configuration Command Reference
124 Router Configuration Guide
Parameters ip-address — The IP address of the IP interface.
Values
black-hole
Syntax [no] black-hole
Context config>router>static-route-entry
Description This command specifies that the route is a black hole route. If the destination address on a packet
matches this static route, it will be silently discarded.
Default no black-hole
bfd-enable
Syntax [no] bfd-enable
Context config>router>static-route-entry>next-hop
Description This command associates the static route state to a BFD session between the local system and the
configured nexthop.
The remote end of the BFD session must also be configured to originate or accept the BFD session
controlling the static route state.
The no form of this command removes the association of the static route state to that of the BFD
session.
Default no bfd-enable
community
Syntax [no] community comm-id
Context config>router>static-route-entry>next-hop
config>router>static-route-entry>indirect
Description This configuration option associates a BGP community with the static route. The community can be
matched in route policies and is automatically added to BGP routes exported from the static route.
The no form of this command removes the community association.
Default no community
ipv4-address a.b.c.d
ipv6-address x:x:x:x:x:x:x:x-[interface]
To Next Page
Loading...
