IP Router Configuration
Router Configuration Guide 125
Parameters comm-id — Speifies the community identifier.
Values
cpe-check
Syntax [no] cpe-check cpe-ip-address
Context config>router>static-route-entry>next-hop
config>router>static-route-entry>indirect
Description This command enables CPE-check and specifies the IP address of the target CPE device.
This option initiates a background ICMP ping test to the configured target IP address. The IP address
can either be an IPv4 address for IPv4 static routes or an IPv6 address for IPv6 static routes. The target-
ip-address cannot be in the same subnet as the static route subnet itself to avoid possible circular
references. This option is mutually exclusive with BFD support on a given static route.
The no form of this command disables the cpe-check option.
Default no cpe-check
Parameters cpe-ip-address — Speifies the IP address of the CPE device.
drop-count
Syntax [no] drop-count count
Context config>router>static-route-entry>next-hop>cpe-check
config>router>static-route-entry>indirect>cpe-check
Description This optional parameter specifies the number of consecutive ping-replies that must be missed to
declare the CPE down and to deactivate the associated static route.
Default 3
Parameters count — An integer count value.
Values 1 to 255
comm-id asn:comm-val, well-known-comm
asn 0 to 65535
comm-val 0 to 65535
well-known-comm no-advertise, no-export, no-export-
subconfed
To Next Page
Loading...
