IP Router Configuration
Router Configuration Guide 133
Context config>router>static-route-entry>indirect>tunnel-next-hop
Description This optional command determines if the associated static route can be resolved via an IGP next-hop
in the RTM if no tunnel next-hops are found in TTM.
When configured, the associated static route will not be resolved to an available IGP route in the RTM.
The no form of the command returns the behavior to the default, which does allow for the static route
to be resolved via an IGP route in the RTM if no tunnel next-hop can be found in the TTM.
Default no disallow-igp
resolution
Syntax resolution {any | disabled | filter}
no resolution
Context config>router>static-route-entry>indirect>tunnel-next-hop
Description This command determines how the associated static route can be resolved to a tunnel next-hop.
Default resolution any
Parameters any — Allows the associated static route to be resolved to any active entry in the TTM, following
the TTM preference order.
disabled — Disables the associated static route to be resolved to any active entry in the TTM. As
a result, the static route can only be resolved via IP RTM resolution of the static route's
nexthop.
filter — Allows the associated static route to be resolved to active tunnels in the TTM using the
resolution-filter restrictions.
resolution-filter
Syntax [no] resolution-filter
Context config>router>static-route-entry>indirect>tunnel-next-hop
Description This command creates the context to specify the tunnel next-hop resolution options.
If one or more tunnel filter criteria are specified, the static route nexthop will be resolved to an
available tunnel from one of those LSP sources. The tunnel types will be selected following the TTM
preference.
Default no resolution-filter
To Next Page
Loading...
