IP Router Configuration Command Reference
132 Router Configuration Guide
If source route policy accounting is enabled and a source-class index is configured, traffic with a source
IP address matches the associated static route, the source accounting statistics for the specified class
will be incremented.
The no form of the command removes the associated destination-class from the associated static route
nexthop.
Default no source-class
Parameters source-index — Specifies an integer value for the accounting source class index.
Values 1 to 255
tag
Syntax [no] tag tag-value
Context config>router>static-route-entry>indirect
config>router>static-route-entry>next-hop
Description This command adds a 32-bit integer tag to the associated static route.
The tag value can be used in route policies to control distribution of the route into other protocols.
Default 1
Parameters tag-value — Specifies an integer tag value.
Values 32 bit integer
tunnel-next-hop
Syntax [no] tunnel-next-hop
Context config>router>static-route-entry>indirect
Description This command enables the static route's nexthop to be resolved to an indirect tunnel next-hop.
The command within the tunnel-next-hop context controls the resolution to tunnel next-hops in TTM.
As such, the user must first configure the prefix with the existing command and the indirect option,
and then enter the new command with the indirect option and with the new static-route-entry
command.
Default no tunnel-next-hop
disallow-igp
Syntax [no] disallow-igp
To Next Page
Loading...
