IP Router Configuration Command Reference
162 Router Configuration Guide
never — When specified, no tunnels will be placed on blacklist under any circumstance. This
parameter will available to preserve backward compatibility.
max-list-length
Syntax max-list-length unlimited
max-list-length count
no max-list-length
Context configure>router>l2tp>tunnel-selection-blacklist
configure>service>vprn>l2tp>tunnel-selection-blacklist
Description This command configured the maximum length of the peer/tunnel blacklist.
This command specifies how many items (tunnels or peers) can be in the tunnel-selection-blacklist. If
a tunnel or peer needs to be added to the tunnel-selection-blacklist and the tunnel-selection-blacklist is
full, the system will remove the item (tunnel or peer) from the blacklist that was in this blacklist for
the longest time.
stop-ccn-other A tunnel will be forced to the blacklist in case that StopCCN message with the
following Result Codes is received:
(1) General request to clear control connection
(4) Requester is not authorized to establish a control channel
(5) Protocol version not supported
(6) Requester is being shutdown
Or in the case that the StopCCN with the following result codes is transmitted:
(4) Requester is not authorized to establish a control channel.
(5) Protocol version not supported
The receipt of the following Result Codes will NEVER blacklist a tunnel:
(0) Reserved
(3) Control channel already exist
(7) Finite state machine error
(8) Undefined
Transmission of the following Result Codes will NEVER blacklist a tunnel:
(1) General request to clear control connection
(3) Control channel already exist
(6) Requester is being shutdown
(7) Finite state machine error
addr-change-timeout A timed-out tunnel for which the peer IP address has changed mid-session
(from the one that is provided initially during configuration) will be forced to
the blacklist. In absence of this configuration option, only the configured peer
for the tunnel will be blacklisted, but not the tunnel itself which now has a
different peer address than the one initially configured.
To Next Page
Loading...
