IP Router Configuration
Router Configuration Guide 163
Default unlimited
Parameters unlimited — Specifies there is no limit.
count — Specifies how many items (tunnels or peers) can be in the tunnel-selection-blacklist.
Values 1 to 65635
max-time
Syntax max-time minutes
no max-time
Context configure>router>l2tp>tunnel-selection-blacklist
configure>service>vprn>l2tp>tunnel-selection-blacklist
Description This command configures time for which an entity (peer or a tunnel) are kept in the blacklist.
Default 5 minutes
Parameters minutes — Specifies the maximum time a tunnel or peer may remain in the blacklist
Values 1 to 60
timeout-action
Syntax timeout-action action
no timeout-action
Context configure>router>l2tp>tunnel-selection-blacklist
configure>service>vprn>l2tp>tunnel-selection-blacklist
Description This command defines an action that will be executed on the entity (peer/tunnel) in the blacklist once
the entity becomes eligible for selection again.
Default remove-from-blacklist
Parameters action — Specifies the Action to be taken when a tunnel or peer has been in the blacklist for the
max-period of time.
Values remove-from-blacklist — The peer or tunnel in the blacklist will
be removed completely from the blacklist and made eligible for
the selection process once the max-time expires. In this mode of
operation, multiple new sessions can be mapped into the same,
newly released tunnel from the blacklist. The first such session
will try to setup the tunnel, while the other will be buffered until
the tunnel establishment process is completed. In case that the
tunnel remains unavailable, it will be placed in the blacklist again.
Consequently all new sessions will have be renegotiated over an
alternate tunnel.
To Next Page
Loading...
