IP Router Configuration Command Reference
226 Router Configuration Guide
min-advertisement-interval
Syntax [no] min-advertisement-interval seconds
Context config>router>router-advert>if
Description This command configures the minimum interval between sending ICMPv6 neighbor discovery router
advertisement messages.
Default 200
Parameters seconds — Specify the minimum interval in seconds between sending ICMPv6 neighbor
discovery router advertisement messages.
Values 3 to 1350
mtu
Syntax [no] mtu mtu-bytes
Context config>router>router-advert>if
Description This command configures the MTU for the nodes to use to send packets on the link.
Default no mtu — The MTU option is not sent in the router advertisement messages.
Parameters mtu-bytes — Specify the MTU for the nodes to use to send packets on the link.
Values 1280 to 9212
other-stateful-configuration
Syntax [no] other-stateful-configuration
Context config>router>router-advert>if
Description This command sets the "Other configuration" flag. This flag indicates that DHCPv6lite is available for
autoconfiguration of other (non-address) information such as DNS-related information or information
on other servers in the network. See RFC 3736, Stateless Dynamic Host Configuration Protocol
(DHCP) for IPv6.
Default no other-stateful-configuration
prefix
Syntax [no] prefix [ipv6-prefix/prefix-length]
Context config>router>router-advert>if
To Next Page
Loading...
