IP Router Configuration
Router Configuration Guide 225
Default No interfaces are configured by default.
Parameters ip-int-name — Specify the interface name. If the string contains special characters (#, $, spaces,
etc.), the entire string must be enclosed within double quotes.
current-hop-limit
Syntax current-hop-limit number
no current-hop-limit
Context config>router>router-advert>if
Description This command configures the current-hop-limit in the router advertisement messages. It informs the
nodes on the subnet about the hop-limit when originating IPv6 packets.
Default 64
Parameters number — Specifies the hop limit.
Values 0 to 255. A value of zero means there is an unspecified number of
hops.
managed-configuration
Syntax [no] managed-configuration
Context config>router>router-advert>if
Description This command sets the managed address configuration flag. This flag indicates that DHCPv6 is
available for address configuration in addition to any address autoconfigured using stateless address
autoconfiguration. See RFC 3315, Dynamic Host Configuration Protocol (DHCP) for IPv6.
Default no managed-configuration
max-advertisement-interval
Syntax [no] max-advertisement-interval seconds
Context config>router>router-advert>if
Description This command configures the maximum interval between sending router advertisement messages.
Default 600
Parameters seconds — Specifies the maximum interval in seconds between sending router advertisement
messages.
Values 4 to 1800
To Next Page
Loading...
