Alcatel-Lucent 7450 - Page 288

Show, Clear, and Debug Command Reference
288 Router Configuration Guide
-------------------------------------------------------------------------------
Network Domain : default
-------------------------------------------------------------------------------
Description : Default Network Domain
No. Of Ifs Associated : 3
No. Of SDPs Associated : 0
===============================================================================
*A:Dut-T>config>router#
*A:Dut-T>config>router# show router network-domains "net1" interface-association
===============================================================================
Interface Network Domain Association Table
===============================================================================
Interface Name Port Network Domain
-------------------------------------------------------------------------------
intf1 1/2/2 net1
intf2 6/1/2 net1
-------------------------------------------------------------------------------
Interfaces : 2
===============================================================================
*A:Dut-T>config>router#
*A:Dut-T>config>service# show router network-domains "net1" sdp-association
===============================================================================
SDP Network Domain Association Table
===============================================================================
SDP Id Network Domain
-------------------------------------------------------------------------------
100 net1
-------------------------------------------------------------------------------
SDPs : 1
===============================================================================
*A:Dut-T>config>service#
policy
Syntax policy [name | damping | prefix-list name | as-path name | community name | admin]
Context show>router
Description This command displays policy-related information.
Parameters name — Specify an existing policy-statement name.
damping — Specify damping to display route damping profiles.
prefix-list name — Specify a prefix list name to display the route policy entries.
as-path name — Specify the route policy AS path name to display route policy entries.
community name — Specify a route policy community name to display information about a
particular community member.