IP Router Configuration
Router Configuration Guide 289
admin — Specify the admin keyword to display the entities configured in the
config>router>policy-options context.
Output Policy Output — The following table describes policy output fields.
Sample Output
B:CORE2# show router policy
===============================================================================
Route Policies
===============================================================================
Policy Description
-------------------------------------------------------------------------------
fromStatic
-------------------------------------------------------------------------------
Policies : 1
===============================================================================
B:CORE2#
policy-edits
Syntax policy-edits
Context show>router
Description This command displays edited policy information.
route-table
Syntax route-table [family] [ip-prefix[/prefix-length] [longer | exact | protocol protocol-name] [all]]
[next-hop-type type] [qos] [alternative] [accounting-class]
route-table [family] summary
route-table tunnel-endpoints [ip-prefix[/prefix-length]] [longer | exact] [detail]
route-table [<family>] [<ip-prefix[/prefix-length]>] [longer | exact | protocol
<protocol-name>] extensive [all]
Context show>router
Description This command displays the active routes in the routing table.
If no command line arguments are specified, all routes are displayed, sorted by prefix.
Table 22: Policy Field Descriptions
Label Description
Policy The policy name.
Description Displays the description of the policy.
To Next Page
Loading...
