Show, Clear, and Debug Command Reference
290 Router Configuration Guide
Parameters family — Specify the type of routing information to be distributed by this peer group.
Values ipv4 — Displays only those BGP peers that have the IPv4 family
enabled and not those capable of exchanging IP-VPN routes.
ipv6 — Displays the BGP peers that are IPv6 capable.
mcast-ipv4 — Displays the BGP peers that are IPv4 multicast
capable.
mcast-ipv6 — Displays multicast IPv6 route table.
ip-prefix[/prefix-length] — Displays routes only matching the specified ip-address and length.
Values The following values apply to the 7750 SR and 7950 XRS:
Values The following values apply to the 7450 ESS:
longer — Displays routes matching the ip-prefix/mask and routes with longer masks.
exact — Displays the exact route matching the ip-prefix/mask masks.
protocol protocol-name — Displays routes learned from the specified protocol.
Values local, sub-mgmt, managed, static, ospf, ospf3, isis, rip, aggregate,
bgp, bgp-vpn
summary — Displays a route table summary information.
tunnel-endpoints — Specifies to include tunnel endpoint information.
next-hop-type tunneled — Displays only the tunneled next-hops. For each route entry, the tunnel
owner and tunnel ID is shown.
Output Standard Route Table Output — The following table describes the standard output fields for the
route table.
ipv4-prefix: a.b.c.d (host bits must be set to 0)
ipv4-prefix-length: 0 to 32
ipv6 ipv6-prefix[/pref*: x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x: [0 to FFFF]H
d: [0 to 255]D
prefix-length: 1 to 128ipv6
ipv4-prefix: a.b.c.d (host bits must be set to 0)
ipv4-prefix-length: 0 to 32
Table 23: Standard Route Table Field Descriptions
Label Description
Dest Address The route destination address and mask.
To Next Page
Loading...
