IP Router Configuration
Router Configuration Guide 313
Description This command displays the router status.
Output Router Status Output — The following table describes the output fields for router status information.
Table 29: Router Status Field Descriptions
Label Description
Router The administrative and operational states for the router.
OSPF The administrative and operational states for the OSPF protocol.
RIP The administrative and operational states for RIP.
ISIS The administrative and operational states for the IS-IS protocol.
MPLS The administrative and operational states for the MPLS protocol.
RSVP The administrative and operational states for RSVP.
LDP The administrative and operational states for LDP.
BGP The administrative and operational states for BGP.
IGMP The administrative and operational states for IGMP.
MLD The administrative and operational states for the MLD protocol.
PIM The administrative and operational states for the PIM protocol.
OSPFv3 The administrative and operational states for the OSPFv3 protocol.
MSDP The administrative and operational states for MSDP.
Max Routes The maximum number of routes configured for the system.
Total Routes The total number of routes in the route table.
ECMP Max Routes The number of ECMP routes configured for path sharing.
service-id state — Current single SFM state
start — Last time this vRtr went into overload, after having respected
the hold-off time
interval — How long the vRtr remained or is in overload
ICMP Tunneling No — ICMP tunneling is disabled.
Yes — TICMP tunneling is enabled.
To Next Page
Loading...
