Show, Clear, and Debug Command Reference
330 Router Configuration Guide
===============================================================================
tunnels : 1
tunnels active : 1
sessions : 1
sessions active : 1
rx ctrl octets : 541
rx ctrl packets : 5
tx ctrl octets : 272
tx ctrl packets : 5
tx error packets : 0
rx error packets : 0
rx accepted msg : 4
rx duplicate msg : 0
rx out of window msg : 0
acceptedMsgType
StartControlConnectionRequest : 1
StartControlConnectionConnected : 1
IncomingCallRequest : 1
IncomingCallConnected : 1
ZeroLengthBody : 1
originalTransmittedMsgType
StartControlConnectionReply : 1
IncomingCallReply : 1
ZeroLengthBody : 3
last cleared time : N/A
===============================================================================
session
Syntax session connection-id connection-id [detail]
session [detail] [session-id session-id (v2)] [state session-state] [peer ip-address] [group
group-name] [assignment-id assignment-id] [local-name local-host-name] [remote-name
remote-host-name] [tunnel-id tunnel-id (v2)]
session [detail] [state session-state] [peer ip-address] [group group-name] [assignment-
id assignment-id] [local-name local-host-name] [remote-name remote-host-name]
[control-connection-id connection-id (v3)]
Context show>router>l2tp
Description This command displays L2TP session operational information.
Parameters connection-id connection-id — Specifies the identification number for a Layer Two Tunneling
Protocol connection.
Values 1 to 429496729
detail — Displays detailed L2TP session information.
session-id session-id (v2) —
Specifies the identification number for a Layer Two Tunneling
Protocol session.
Values 1 to 65535
To Next Page
Loading...
