IP Router Configuration
Router Configuration Guide 339
tunnel tunnel-id tunnel-id (v2) [statistics] [detail]
tunnel connection-id connection-id (v3) [statistics] [detail]
Context show>router>l2tp
Description This command displays L2TP tunnel operational information.
Parameters statistics — Displays L2TP tunnel statistics.
detail — Displays detailed L2TP tunnel information.
peer ip-address — Displays information for the the IP address of the peer.
state tunnel-state — Displays the operational state of the tunnel.
remote-connection-id remote-connection-id (v3) — Displays information for the specified
remote connection ID.
group group-name — Displays L2TP tunnel information for the specified tunnel group.
assignment-id assignment-id — Specifies a string that distinguishes this Layer Two Tunneling
Protocol tunnel.
local-name host-name — Specifies a local host name used by this system.
remote-name host-name — Specifies a remote host name used by this system.
connection-id connection-id — Specifies the identification number for a Layer Two Tunneling
Protocol connection.
Values 1 to 429496729
detail — Displays detailed L2TP session information.
session-id session-id (v2) — Displays information for the specified the L2TP session.
Values 1 to 65535
state session-state — Displays the operational state of the L2TP session.
Values closed, closed-by-peer, draining, drained, established,
established-idle, idle, wait-reply, wait-conn
peer ip-address — Displays information for the specified peer IP address.
Values The following values apply to the 7750 SR:
Values The following values apply to the 7450 ESS:
ipv4-address: a.b.c.d (host bits must be 0)
ipv4-address a.b.c.d (host bits must be 0)
ipv6-address x:x:x:x:x:x:x:x[-interface]
x:x:x:x:x:x:d.d.d.d[-interface]
x: [0 to FFFF]H
d: [0 to 255]D
interface: 32 characters maximum, mandatory for link local
addresses
To Next Page
Loading...
