Filter Policies
Router Configuration Guide 525
Context config>filter>log
Description This command configures the destination for filter log entries for the filter log ID.
Filter logs can be sent to either memory (memory) or to an existing Syslog server definition (syslog).
If the filter log destination is memory, the maximum number of entries in the log must be specified.
The no form of the command deletes the filter log association.
Default no destination
Parameters memory num-entries — Specifies the destination of the filter log ID is a memory log. The num-
entries value is the maximum number of entries in the filter log expressed as a decimal
integer.
Values 10 to 50000
syslog syslog-id — Specifies the destination of the filter log ID is a Syslog server. The syslog-id
parameter is the number of the Syslog server definition.
Values 1 to 10
shutdown
Syntax [no] shutdown
Context config>filter>log
config>filter>log>summary
Description Administratively enables/disables (AdminUp/AdminDown) an entity. Downing an entity does not
change, reset or remove any configuration settings or statistics. Many objects must be shutdown before
they may be deleted.
The shutdown command administratively downs an entity. Administratively downing an entity
changes the operational state of the entity to down.
Unlike other commands and parameters where the default state will not be indicated in the
configuration file, shutdown and no shutdown are always indicated in system generated
configuration files.
The no form of the command puts an entity into the administratively enabled state.
Default no shutdown for config>filter>log and shutdown for config>filter>log>summary
summary
Syntax summary
Context config>filter>log
To Next Page
Loading...
